4B Sensor Mounting Kit
Sensor mounting kits for barrel sensors
SMK-30, SMK-30-R, SMK-18, SMK-18-R, SMK-U, SMK-U-R

The 4B Sensor Mounting Kit is able to securely mount barrel sensors in position, including 4B’s range of 18 & 30mm wide inductive sensors.

Made of Stainless Steel and Nylon 66, giving corrosion resistance as well as abrasion resistance and high melting points, the brackets are ideal for harsh environments.
A flexible mounting head and foot can be rotated independently before being locked in the required position using the supplied screws.

4B sensor mounting kit
Product Features
  • Secure Fixing
  • Simple Mounting
  • Robust Design
  • Flexible Mounting through 360°
  • Works with Threaded or Smooth Bodied Sensors
    Literature Downloads

    M1003 Stopswitch

    M100 Stopswitch
    M1003 Stopswitch

    The M1003 Stopswitch is a simple inductive shaft speed monitoring device. The self-contained unit, which signals when the shaft has stopped rotating. It can be used for process control, motion detection and stopped shaft indication. An inductive sensing device located in the nose of the M100 enclosure will detect a metal target. This target can be an existing bolt head or device attached to a shaft. The M1003 Stopswitch requires no calibration and provides an output when the shaft has stopped rotating.

    DANE PRODUKTU

    M3003, M3008 & M3007 Slipswitch

    M3003 & M3007 Slipswitch
    M3003, M3008 & M3007 Slipswitch

    The M300 Slipswitch is an easy-to-use inductive proximity shaft speed monitoring device with an adjustable 0 - 30 second start-up delay, all housed in a 30 mm diameter moulded body. The self-contained unit has a single set point, which signals when the shaft speed has dropped by 20% of normal running speed. It is used for detecting dangerous slow down and underspeed conditions on conveyors, bucket elevators, air locks, mixers, fans, grinders and many other machines. 

    No connection is necessary between the sensor and the equipment being monitored. The proximity sensor detects a stud or bolt mounted on a shaft, or other suitable target. Ideally, the target should be of ferrous metal, but non-ferrous metal will be detected at a shorter range. Maximum range of ferrous targets is 8 mm (5/16”) and for non-ferrous targets is 5 mm (6/16”), assuming a 20 mm (3/4”) diameter target. Smaller targets may be used but operating distances will be reduced.

    DANE PRODUKTU

    Milli-Speed Switch

    4B  Milli speed switch (ATEX version)
    Milli-Speed Switch

    The Milli-Speed Sensor has a 4-20 mA output proportional to calibrated speed, it is designed to allow detection of belt slip & underspeed, stop motion, low speed or zero speed on bucket elevators, conveyors, airlocks, mixers, fans, grinders and many other rotating machines.  Totally sealed and simple to calibrate, the Milli-Speed works in the harshest of conditions.

    An inductive sensing device located in the nose of the Milli-Speed enclosure will detect a metal target. This target can be an existing bolt head or device attached to a shaft, such as 4B’s Whirligig® sensor mount. During installation, the Milli-Speed is set to the normal running RPM by simple magnetic calibration.

    DANE PRODUKTU