Rotech Encoder - Stainless Steel
Heavy Duty Shaft Encoder
SSE 2000

The 4B heavy duty stainless steel Rotech rotary shaft encoder is used primarily for protecting equipment and personnel from dangerous underspeed/belt slip conditions in extreme environments. Other applications include accurate speed control, direction of rotation detection, gate position indication and counting the number of revolutions of the shaft. An inductive sensing device in the body of the encoder detects a steel rotor. On slow speed or accurate position control, a photo diode detects the slots on a steel disk. One pulse is created for each rotor or slot so the unit can be connected directly to a PLC/computer or 4B control module. The shaft to be monitored is drilled and taped to take the 1/2 in. UNC Rotech Bolt. The unit is secured to the shaft with this bolt and is able to move with the shaft. No guards are required as the rotating components are encased inside the housing of the encoder. No brackets are required as the encoder couples directly to the end of the shaft and floats with the shaft.

Rotech shaft encoder - stainless steel
Product Features
  • Rotating shaft monitor
  • 304/316 stainless steel housing
  • Provides information on shaft speed, direction, position or revolution
  • For conveyors, elevators, mixers, fans, pumps, grinders & other mechanical handling systems
  • Ultra heavy duty version - suitable for the most severe industrial environments 
  • IP67
Electronics Application

Belt Conveyor

Belt Conveyor

Bucket Elevator

Bucket Elevator
Certification

ATEX

ATEX
Image
ATEX Logo

UKEx

UKEx
Image

IECEx

IECEx
Image
IECExv3

CSA

CSA
Image
CSA logo

CE

CE
Image
CE Logo
    Literature Downloads

    The shaft is turning, but there is no signal coming from the sensor. What is the problem?  
      The bolt connecting the encoder to the shaft is not tight. Remove the back plate and tighten down the connecting bolt with a hex key (Allen wrench).
    Note: the hex key will be under a plastic cap, be sure to replace this cap before reassembling the back plate on the encoder.