A Worldwide Manufacturer of high quality, technologically advanced material handling & electronic components.
Sales or Technical Support:
+ 66 (0) 2173-4339
Click here to Contact Us
Detects level or plug situations for bulk granular solids or liquids in tanks, bins, or silos and can be used as a plug or choke detector in chutes, conveyors and elevator legs.
Need advice to make your bucket elevator safe?
Click here to get a free recommendation.
Polyethylene abrasion shield with outdoor weather cap.
Urethane compression fitting mount for use with Binswitch. 11/4-inch NPT external thread.
Teflon Abrasion Shield screw-on end cap for ATEX Binswitch.
Plastic gland mount for use with the Binswitch.
The adjustable depth level kits are an ideal solution for the quick installation of capacitive level indicators in variable heights. On demand, they can be delivered with the sensor pre-installed and configured.
Mild steel powder coated mounting flange with 11/4-inch NPT or 1 inch BSP, half or full coupling. Ensures a solid fixing to tanks silos and bins. Suitable for Binswitches, Rotosafes, Autoset .
Supplied complete with weather gasket. (Also available in stainless steel).
The Watchdog™ Elite is a microprocessor controlled unit with combined belt speed, belt alignment, bearing temperature, pulley alignment and plugged condition monitoring for bucket elevators and conveyors. An LCD screen displays machine status messages (available in four different languages) and a super-bright LED display shows belt speed. Calibration and set-up parameters are accessed via a password and front panel touch buttons.
The B400 Elite Beltswitch belt misalignment monitor uses 4B Touchswitch sensors to monitor belt alignment in bucket elevators and conveyors. Each control unit incorporates two independent monitoring circuits for early detection of belt misalignment on one or two bucket elevators / conveyors. The 4B Touchswitch is an electro-mechanical limit switch with no moving parts. When a belt misaligns or a pulley moves over and contacts the sensor, the built in solid-state electronic circuitry detects the lateral force of the belt or pulley and activates a voltage free relay contact.
The X400 Elite is a microprocessor controlled low cost alarm indicator panel for use with level indicators, hazard controls and limit switch sensors. The X400 accepts signals from different sources in up to 8 zones, and is able to cause alarm and shutdown of the machine when an alarm condition has been detected. Alarm and status LEDs on the lid of the X400 provide quick location of alarm conditions. Alarm muting can be performed at the panel or by an optional remote push button to silence external alarms.
What is the range of the Binswitch?
Typical sensing range is 1 inch (25 mm).
Preventative maintenance can help reduce the risk of equipment failure and consequent downtimes. When it comes to monitoring your bucket elevators and belt conveyors, 4B can recommend you the ideal combination of sensors and monitoring systems to suit your requirements and budget.
4B provides an extensive range of their own ATEX / IECEx / CSA /GOST- R approved hazard monitoring systems, misalignment switches and bearing temperature monitors and level controls. We can offer you anything from a replacement sensor to a fully integrated hazard monitoring system which can be operated either as a stand-alone system or connected to your PLC.
And if you do not want to install hazard monitoring sensors on every piece of equipment in your plant straightaway, we can offer you a scalable solution starting with carefully chosen equipment and systems that can be expanded at a later date to encompass other machines in the plant.
We can also offer you an installation service, and we do provide a competent after-sales technical service to help you overcome any technical problems with your monitoring equipment.
To get a recommendation from our engineers, please fill in the electronics questionnaire below. Please fill this form in as accurately as possible to allow us to deal with your enquiry more effectively.
If you would like to send us a technical drawing or document with your enquiry, please send to email@example.com.